- Joined
- Dec 16, 2018
- Messages
- 1,189
- Reaction score
- 2,811
Try a 3.3k first.Yeah this is my original proto hat (star config) that I have had working for sometime but the SD card decided to go sideways. It was all working fine in the past but the three probe temps were all using the same length cable. I swapped one of the probes out with a longer cable unit and I also took the liberty of replacing the audio jacks with jst-xm connectors. I would assume I am using whatever resistor was called out in the temp guide, I did purchase a box of resistors so I can replace it with a different value, which one should I try first or most likely to work? I
The resistor pulls the data line back up to 3.3v
If there is excess capacitance in the wiring the 4.7k may not pull up the data line fast enough and commmunications on the bus get interuppted. A smaller resistor will charge the capacitance faster, but too small will waste power and/or allow too much current to flow and burn out the pi pin so go incrementally smaller until it works.


