The Mediocreef

[Mschmidt]

Mer

Beautiful! Merry Christmas!

Merry Christmas!

 

[LadyMac]

Merry Christmas

 

[Reeflix]

Merry Christmas!

 

[Mschmidt]

Got home last night too a wet rug in front of the reef.

The e drain 1 was spraying through a small gap.

Got what I could cleaned up . Good thing it's not raining for three next week.

Would have been a great opportunity to use this.

 

[Mschmidt]

Is it some kind of sponge?

 

[LadyMac]

Looks like what’s all on the back of my rock in the tank, which was said to be sponge and safe.

I’m no expert though so….

 

[Mschmidt]

Looks like what’s all on the back of my rock in the tank, which was said to be sponge and safe.

I’m no expert though so….

Thought it might be the way it's growing. It's in my overflow box so as long as it stays out of the drain I'm good with it.

 

[tbrown]

I dunno... I have a red sponge that may have killed an Acro. It was growing up the base, then the Acro died, then the sponge covered it. Could just be a coincidence since it seems most of my Acros are doing poorly...

 

[Mschmidt]

I dunno... I have a red sponge that may have killed an Acro. It was growing up the base, then the Acro died, then the sponge covered it. Could just be a coincidence since it seems most of my Acros are doing poorly...

Haven't seen anything like it in the tank though. Just the overflow.

 

[tbrown]

Haven't seen anything like it in the tank though. Just the overflow.

Mine tends to stay in th extreme dark places in the tank. Except that one acro.

 

[Mschmidt]

Maybe I'll go sump creeping at some point.

 

[Mschmidt]

Fine I'll test. But I'll grumble the whole time.

 

[Mschmidt]

Grumble grumble grumble.

Calc. 500<x>520

Holy phos batman!

 

[Mschmidt]

Just set up a new reactor. Rowaphos and carbon, we'll see what happens to these...

 

[Mschmidt]

Data tracker tracking data.

I invented most of my calc numbers...

 

[Mschmidt]

Grrr.
@Projects with Sam and or @stoney7713 need to dry the filament or slow it down/heat it up?

 

[tbrown]

Unclog the nozzle probably?

 

[tbrown]

I could be wrong though. It just looks like a clogged nozzle or eSteps.

 

[stoney7713]

Grrr.
@Projects with Sam and or @stoney7713 need to dry the filament or slow it down/heat it up?

What material? What are the nozzle temps? In a way it looks like the heat is too low, no layer adhesion, dragging the filament apart.

 

[Mschmidt]

Unclog the nozzle probably?

It extruded fine when it wasn't printing. That was the first thing I looked at.

What material? What are the nozzle temps? In a way it looks like the heat is too low, no layer adhesion, dragging the filament apart.

Petg, 240 no cooling. I can crank it, but should be ok there.

It was after a few tpu prints, that may have caused some sticking. Not sure.

Got the same thing going now with pla, 200 maybe cooling, didn't look. And it's fine.