Hello all,
Recently purchased a RODI unit with a TDS measure and pressure gage and as so many other threads and questions I have seen, the initial set up is giving me some trouble and would love some insight.
The unit is a 4 stage BRS RODI unit. I believe I set it up correctly, but could be wrong, but for some reason the pressure gage is reading extremely low. Now, I am not completely convinced it’s the pressure coming from my water source as I have done some testing that seems to have the pressure going into the system. I removed the red line from the “t” adaptor and I would say the water was very strong. I removed all tubes from the system at different points and still nothing. I have used the flush value, by running it for 30 mins then turning it on and off 10* times, then blowing in it. I have removed all the cartridges and checked to make sure they are upright. Still nothing. I realize that water isn’t getting to the last stage of DI resin, and all coming out the waste line, with a lot of pressure. Would love if anyone had any suggestions or idea what it could be, before I go and by a booster, something I’m not sure is the true solutions.
Any insight would be great. Thanks ahead of time.
Recently purchased a RODI unit with a TDS measure and pressure gage and as so many other threads and questions I have seen, the initial set up is giving me some trouble and would love some insight.
The unit is a 4 stage BRS RODI unit. I believe I set it up correctly, but could be wrong, but for some reason the pressure gage is reading extremely low. Now, I am not completely convinced it’s the pressure coming from my water source as I have done some testing that seems to have the pressure going into the system. I removed the red line from the “t” adaptor and I would say the water was very strong. I removed all tubes from the system at different points and still nothing. I have used the flush value, by running it for 30 mins then turning it on and off 10* times, then blowing in it. I have removed all the cartridges and checked to make sure they are upright. Still nothing. I realize that water isn’t getting to the last stage of DI resin, and all coming out the waste line, with a lot of pressure. Would love if anyone had any suggestions or idea what it could be, before I go and by a booster, something I’m not sure is the true solutions.
Any insight would be great. Thanks ahead of time.