it would probably be similar to a colander - you know, the thing you drain your noodles with - LOLWhat about the holes in the cup?
I'll draw something up
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
it would probably be similar to a colander - you know, the thing you drain your noodles with - LOLWhat about the holes in the cup?
Nice! I've gotten the most joy out of 3dprinting some of the simplest things you could think of. It's really a hobby that's made to compliment tons of other niche hobbies.Made these for a friend of mine, very simplistic but get's the job done.
Shelves for the litermeter iii master and slave
Master:
Slave (also can be used for the ATO UPLC II)
Thingiverse Master
Thingiverse Slave
PETG is a pretty sure bet - its what we us to print all our parts that are designed for use in the waterCan a use PLA or only PETG ( reef save )
PETG is a pretty sure bet - its what we us to print all our parts that are designed for use in the water
However, some brands of PLA seem to have no issues. I've had PLA parts printed in eSun PLA Plus filament in my personal tank for more than year with no visible signs of any issues. Most of the PLA-Plus, -Pro filaments out there are usually blended with varying degrees of PETG or ABS
I bet that would work. Except I might try a cone on the bottom instead.OK - I'll go against the grain here - make a slight design change to the cup. Make the bottom more like a dome , flip the part over and print it with NO supports
it will be faster and you wont have to clean much up.
Can you send me some brands of PLA you are using and PETG I have Ender 3 pro printer I tried print PETG but no luck thx
I can tell you from using over a dozen rolls of it that HQA PETG is very easy to print on my three enders. Plus, the colors are just amazing.
If you buy two rolls at once on their site, shipping is free.
The also have partial rolls so you can test.
Made these for a friend of mine, very simplistic but get's the job done.
Shelves for the litermeter iii master and slave
Master:
Slave (also can be used for the ATO UPLC II)
Thingiverse Master
Thingiverse Slave
I use HQA PLA+ and Currently have a couple things in my sump that are 3D Solutech PLA.
it would probably be similar to a colander - you know, the thing you drain your noodles with - LOL
I'll draw something up
Can you share your Ender 3 PETG settings ?
I bet that would work. Except I might try a cone on the bottom instead.
here's rough idea. I think it would work, but the bottom of the cup may need just bit less round for it to print cleanly with no supports
we pretty much exclusive us eSun filament. When we are printing in PLA, it's usually the PLA+ versionCan you send me some brands of PLA you are using and PETG I have Ender 3 pro printer I tried print PETG but no luck thx