HELP!!! Since day one that I installed 2 MP60's and 2 MP40's I have not been able to try Gyre Mode due to stall error. At first the MP60 master and opposite side MP40 would work fine but the other 2 pumps would stall. Noticed that the opposite side MP40 would still be running at a very low speed but the other 2 slave pumps that would give a stall error were completely stopping when in anti-sync of the master. Called Ecotech support and they told me to do the phone shake and submit a ticket which I did and the next day I was sent OS updates from engineering. Installed updates and now all slave pumps stall out in Gyre mode. The MP40 that would run at a very slow speed and not stall out now stops like the others and stalls. Called support again and talked with two support technicians and the both told me that they believe when in Gyre that the pumps should never stop completely. They should only slow way down. I asked if they are supposed to slow down below there advertised minimum speed and both said yes which makes sense because if the MP40's ( 1600gph min ) and MP60's ( 3600gph min ) only slowed down to advertised minimum speed that would defeat the purpose of Gyre Mode. Another ticket has been submitted but I have not heard anything from them. Been 2 weeks.
Has anyone else seen this issue running Gyre ( Mobius )? If running Gyre Mode do your pumps stop or run slow when alternating?
All other modes work fine and never stall.
All my pumps are clean.
Has anyone else seen this issue running Gyre ( Mobius )? If running Gyre Mode do your pumps stop or run slow when alternating?
All other modes work fine and never stall.
All my pumps are clean.