PSI at 60, do I need a Booster Pump

Hair Algae Wizard

Well-Known Member
View Badges
Joined
Aug 26, 2012
Messages
610
Reaction score
1,030
Location
Southern, NJ
What state or country do you live in
New Jersey
Rating - 0%
0   0   0
Folks,

I have a 200gpd, 7 stage RO/DI system I purchased from Bulk Reef. My pressure meter is showing 59-60PSI, is this sufficient for effective use, or should I consider a booster pump?

Thanks in advance for any advice.

-B
 
Folks,

I have a 200gpd, 7 stage RO/DI system I purchased from Bulk Reef. My pressure meter is showing 59-60PSI, is this sufficient for effective use, or should I consider a booster pump?

Thanks in advance for any advice.

-B
Following along. I have 7 stage 150 GPD running at 65 psi. Curious to hear others thoughts.
 
If it's a dual membrane setup like I think it is, I would highly suggest a booster pump. I have a dual 90GPD system and 85PSI going into the first membrane and only 45 going into the second. So I'd be willing to bet your second membrane is suffering from rather low PSI.
 
Folks,

I have a 200gpd, 7 stage RO/DI system I purchased from Bulk Reef. My pressure meter is showing 59-60PSI, is this sufficient for effective use, or should I consider a booster pump?

Thanks in advance for any advice.

-B

Product states 65-80 psi for optimal use/rejection rate. Maybe thing about that booster pump.
 
One thing to watch is if you do add a booster pump, make sure all chlorine is removed before entering your membrane. I had two 10” cartridges to remove chlorine / chloramines which worked fine until I increased the flow and there was not enough contact time. I have since added the chloramine blaster which is 4” x 20”
 
Thanks folks. I just ordered a booster pump. It's adjustable, so I can control the amount of pressure, and will keep it around 65-70 PSI.
 
THe more stages the more pressure drop. The membrane needs ~ 50 PSI but if you have 3 stages (say sediment and 2 carbon blocks or vice-versa), and the incoming pressure is 50-60PSI, it will be far lower by the time it reaches a membrane, especially after few weeks of use.

Throw a gauge right before the membrane housing to see the actual pressure reaching the membrane.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.9%
  • Fish or coral food

    Votes: 5 5.6%
  • Test kits or reagents

    Votes: 9 10.0%
  • Filter media or replacement fleece

    Votes: 5 5.6%
  • RO/DI filters or supplies

    Votes: 14 15.6%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.1%
  • I keep a backup of everything

    Votes: 23 25.6%
  • Other (Post in the comments)

    Votes: 7 7.8%
Back
Top
Home
Post thread…
Market
What's new