The Mediocreef

So I really like those low profile magnetic frag mounts!!
IMG_2476.jpeg
 
They're great! They get expensive to simply encrust over, but that's why I made the suction cup version.
IMG_20240630_102735706.jpg
IMG_20240630_102725875.jpg
IMG_20240630_102719643.jpg
IMG_20240630_102715156.jpg
I used the other to sick the chalice on …..maybe I’ll clean the glass and get a picture
 

Attachments

  • IMG_3029.png
    IMG_3029.png
    249.8 KB · Views: 61
Yup, that was me. So far I'm finding the silver mylar bags the most reliable (using my old as dirt equipment), so might just go with those.
What are you putting in these bags??
 
What are you putting in these bags??
So far I've only been testing them with water and frag plugs to see if they leak. Admittedly, my work on this is very slow. Idea is to send some frags around.
 
So far I've only been testing them with water and frag plugs to see if they leak. Admittedly, my work on this is very slow. Idea is to send some frags around.
So silver Mylar on the outside of the bag?? I wouldn’t thing that would work. Interesting.

I’ve done the sealed bag for shipping before. Never had leak issues. Put the sealer on the edge of the table so the bag could hang a bit. Seal a little higher up from the water line and then seal at the water line leaving no air. Hard part was getting the temp right so the second didn’t just cut through the bag. Or not letting it sit as long under the sealer.
 

WHICH PART OF YOUR SETUP IS HARDEST TO REACH OR REMOVE FOR ROUTINE MAINTENANCE?

  • Glass behind or beside the tank

    Votes: 6 31.6%
  • Powerheads or wavemakers

    Votes: 2 10.5%
  • Sump or rear filtration chambers

    Votes: 2 10.5%
  • Skimmer or other filtration equipment

    Votes: 1 5.3%
  • Overflow or plumbing

    Votes: 5 26.3%
  • Lights or lids

    Votes: 0 0.0%
  • Mine is pretty easy to access!

    Votes: 2 10.5%
  • Other—tell us what I missed

    Votes: 1 5.3%
Back
Top
Home
Post thread…
Market
What's new