Waterbox door assembly.

[grump]

Hey everyone! I leveled my stand today, put the sump in, and tried to install the door. I was having a hard time getting it straight. Well, I pulled out the screw inserts on the cabinet side. I suppose I overtightened them. It didn't seem to take too much. I guess it's time to go to Lowe's and get some new ones and some glue. Has anyone else done this? What did you do? I'm having one of those days.

 

[exnisstech]

For stripped holes I like to stick wooden toothpicks in the holes and break them off flush then start the screw. Been doing that for years. There are a two screws on each hinge for adjustment purposes. The fastening screws get snugged and are not used at all to adjust. I just set up a 330.7 so I had to adjust 4 doors.