Eckolancer
LED GURU
I have recently switched (3 months ago) to a cal reactor from 2 part. Still working on dialing in since then. Measurements before were alk 9 cal 450 mag 1450-1500. Now with cal reactor it is alk 13.4-14 cal 420, mag 1480. I have dialed back when the reactor turns on the c02, slowed effluent to a med drip. I had it at a fast drip raised alk way to fast. Slowed it to a slow drip dropped cal too fast and water was getting stale in the reactor. Just can't seem to dial it in right, any thoughts? My issue is why wont it raise the cal and alk at same levels? Seems like cal even if extra cal is added will always drop back to 420. Now alk will always raise up.
