I have acquired a Tenecor 240. This came from a lfs shutting down and was their "display" cichlid tank. Tank seems to have seen its fair share of rock and sand in its day.
I am going to buff, sand and buff, or polish as needed to remove as many scratches as I can and get a clear tank again. Just figured I would make a thread about how I do it. My way isn't the only way, and I will take any and all suggestions along the way.
Currently I have Novus 1,2,&3, 1/4" sheet sander with 80,120,&220 grit paper. I have a 7" polisher used for cars and two new wool pads and a wool finished pad. Also I have a powerball and a powercone for insides and corners. All pads are new to keep down on contaminates from car products.
I am going to buff, sand and buff, or polish as needed to remove as many scratches as I can and get a clear tank again. Just figured I would make a thread about how I do it. My way isn't the only way, and I will take any and all suggestions along the way.
Currently I have Novus 1,2,&3, 1/4" sheet sander with 80,120,&220 grit paper. I have a 7" polisher used for cars and two new wool pads and a wool finished pad. Also I have a powerball and a powercone for insides and corners. All pads are new to keep down on contaminates from car products.