vetteguy53081
Well known Member and monster tank lover
Ultimate Member
Reef Squad
Excellence Award
Reef Tank 365
RGB
Photo of the Month
R2R Secret Santa 2024
R2R App User
Secret Santa
Article Contributor
Tampa Bay Reef Keepers
West Palm Beach Reefer
Hospitality Award
Ocala Reef Club Member
305 Reef Club
Wisco Reefers
Midwest Reefer
Fish Medic
MAC of SW Florida
Rock Pool Reef Keepers
ThreadAward
My Tank Thread
My Aquarium Showcase
This is by ELOS ( high quality manufacturer) and used a month, and had sitting. I figured someone can use this easy to set up unit.
this was $199 and selling at $85 shipped. Very clean and comes with manual and warranty/registration card (never registered !!)
The entirely new OSMOCONTROLLER Digital uses a patent pending sensor with no moving parts as the first measure of the water level in the SUMP. Most other systems will use multiple float switches or sensors to act as back up to the initial float switch, elos does not. We believe the float switch or sensor will always be the weak link as it is usually a moving part and/or in direct contact with the water, most of the time. To provide an adequate fail-safe the OSMOCONTROLLER Digital uses a small microprocessor in combination with our patent pending sensor to control the pump and monitor the top off of your system. In the event of a fault such as an empty reservoir, a damaged pump or kinked tube, the microprocessor will recognize this and a red alarm LED will indicate the problem and stop pumping until the problem is fixed and the controller can be reset. The OSMOCONTROLLER Digital also has a manual top off button that can be used to use the system as a pump for occasional water changes and to fill a container with RO/DI water easily.
The set up of the OSMOCONTROLLER Digital is very simple. It works with most sumps without the need for programming and with our sensor design has a built in buffer for waves and small changes in the sump that will normally cause a top off system to unnecessarily top off, which will shorten the useable life of the top off pump.
Key Benefits of the OSMOCONTROLLER Digital:
this was $199 and selling at $85 shipped. Very clean and comes with manual and warranty/registration card (never registered !!)
The entirely new OSMOCONTROLLER Digital uses a patent pending sensor with no moving parts as the first measure of the water level in the SUMP. Most other systems will use multiple float switches or sensors to act as back up to the initial float switch, elos does not. We believe the float switch or sensor will always be the weak link as it is usually a moving part and/or in direct contact with the water, most of the time. To provide an adequate fail-safe the OSMOCONTROLLER Digital uses a small microprocessor in combination with our patent pending sensor to control the pump and monitor the top off of your system. In the event of a fault such as an empty reservoir, a damaged pump or kinked tube, the microprocessor will recognize this and a red alarm LED will indicate the problem and stop pumping until the problem is fixed and the controller can be reset. The OSMOCONTROLLER Digital also has a manual top off button that can be used to use the system as a pump for occasional water changes and to fill a container with RO/DI water easily.
The set up of the OSMOCONTROLLER Digital is very simple. It works with most sumps without the need for programming and with our sensor design has a built in buffer for waves and small changes in the sump that will normally cause a top off system to unnecessarily top off, which will shorten the useable life of the top off pump.
Key Benefits of the OSMOCONTROLLER Digital:
- No moving parts
- Very easy setup. (System runs a 5 minutes self-diagnostic test when it is first plugged in.)
- Maintains a very accurate level, very important in marine systems for a stable salinity level when keeping delicate animals.
- Adapts to most aquarium/sump sizes automatically.
