How are you mounting your UV sterilizer?

[oldenred]

I have the Pentair 80 W 6 inch PVC sterilizer just curious what you’re using to mount it. I was thinking about going with a vertical mount I can’t find anything to work with it.

 

[ochriso]

I did vertical with Velcro strapping .

 

[UCF Alum]

I did vertical with Velcro strapping .

+1

 

[Breadman03]

My AquaUV is hung with a few 2” PVC hangers.

 

[oldenred]

Yeah, my pipe is 6” and near 4’ long. Ended up hanging it horizontally under the tank over the sump.

 

[Ocelaris]

For those who mounted it horizontally, did you have any trouble with the air getting stuck? I want to mount mine at the top of the stand, but that wouldn't leave much room for the air to escape. I would normally run it at very low speed, but I suppose i could try and purge the air when I made the changes to replace the lamp etc...

 

[Breadman03]

Mine is mounted horizontally and I have no issues, though I did use a level to ensure the water would flow back and forth easily. I have an Aqua UV 80 watt, which directs water down one pipe, then to the other pipe and back to the same end it started.

 

[Kmsutows]

Mine is just laying in front of the sump horizontally and I try to have the outlet side a little higher. If it was vertical I'd say inlet on bottom of course

 

[Jet915]

Yeah, I lay mine on the ground behind my stand. Luckily, I left enough space where it could squeeze in, it's so big.

 

[Flippers4pups]

I diagonally mounted mine to allow air to escape. Danner pondmaster.

 

[WVfishguy]

My AquaUV is hung with a few 2” PVC hangers.

Mine as well.

 

[JoshH]

I wonder if these would have worked as well, be difficult for maintainence though. Velcro seems like a great option for a vertical mount:)

https://www.pvcfittingsonline.com/6-pvc-2-hole-pipe-strap-strp-060.html