- Joined
- May 11, 2019
- Messages
- 3,557
- Reaction score
- 12,222
It's hard to get a good angle so you can see. However, the back pipe is slightly higher than the front one. The front one was cut. Please don't mind the plastic bag I was testing if one sump could handle all the tank's water without overflowing. If I take the bag off, water will flow down the back one, just at a lower volume then the front.can you get pics of ,where cut ?
pipe going into sumps ?
anything else ,you think needs addressing...
However, if I add valves on the drain line, couldn't I help regulate how much water is going through them and try to correct the height difference. Then with the added gate valve downstairs, control the return draw from each sump?
Another question. In my sump, the ball valve is right next to the tee. How do I cut the valve out and add a new gate valve? Or should I leave the valve in and add the gate valve next?