So trying to make sure I actually installed this upgrade kit properly. My original setup was a 4-Stage RODI 100 GPD w/ a PSI Booster CDP 8800 which I had set to 90 PSI. Here's how I have it setup which I believe is correct and I'm getting waste/product like I would with my continued 90 PSI at the gauge. I personally don't see much of a waste or product difference after the upgrade but maybe it is me. I haven't done like a bucket timed comparison on waste/product. I originally saw a noticeable boost in product when I added the PSI Booster going from 60 PSI to 90 PSI.
Each membrane I believe is rated for 100 GPD so essentially I believe this means it's now a 200 GPD setup?
I've never seen the DI Resin Filter fill up much more than an inch or two before and after this upgrade, is that normal?
On the membranes the product lines are connected to the furthest out connections and the waste is the furthest in.
Each membrane I believe is rated for 100 GPD so essentially I believe this means it's now a 200 GPD setup?
I've never seen the DI Resin Filter fill up much more than an inch or two before and after this upgrade, is that normal?
On the membranes the product lines are connected to the furthest out connections and the waste is the furthest in.