- Joined
- Jan 6, 2017
- Messages
- 2,325
- Reaction score
- 2,293
Great comparison ditto. Someone should hire you to be their product manager ha ha.As promised updated Powerbar charts
Last edited:
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Great comparison ditto. Someone should hire you to be their product manager ha ha.As promised updated Powerbar charts
Don't encourage @Ditto . He's cost me enough money as it is.Great comparison ditto. Someone should hire you to be their product manager ha ha.
Ha ha haDon't encourage @Ditto . He's cost me enough money as it is.
Vortech Pumps Configured Part 2
Thank you crabs_mcjones and Vinny@GHLUSA or helping me out on the Vortech Issues.
Following crabs_mcjones post to do a hard reset(https://www.reef2reef.com/threads/new-vortech-controller-install-issue.331836/#post-4130159) I was able to pair all 3 controllers to the GHL Vortech Control. Per Vinny@GHLUSA, I will not see a status of my pumps as a software upgrade is coming to allow us to see QD status within the controller.
Once the pumps are assigned you can edit the pumps schedules
Above is my Daily schedule following closely what I had before which was having a high and low tide. The Green dot is the one that is currently active.
Some things you need to remember:
Your pump intensity is 1 to 255, so if you want for example 70% of the pump intensity it is 70% of the 255 so approx 179.
When I first did my pumps I set them all to 1-100 thinking 1 was the lowest and 100 was the highest and started to scratch my head looking at the pumps every few hours going why are they running so low.
I was unable to do this anywhere in the myghl web application, and until the software is updated you will not know the status of your pump, if it is for example stalled or offline.
I ordered these. They work very well.KH Director issues
Anyone ever have an error that says “Tritation taking too long”?
Also, issues with their 4mm silicone tubing falling of the small plastic connectors?
If so, how did you remedy this?
My KH Director has been all over the place for the last few days and I have already tried recalibrating the pumps, the probe, and flushing everything over and over again.
I ordered these. They work very well.
https://www.usplastic.com/search/?i...be ID Natural Polypropylene Reduction Coupler
I use the ones that came with the pump and they hold good in place.
You just need to push the tubing over the large part of the connector.
On my side I cut off the smallest part of the connectors and use a Dremel high speed cutter bit to pass it side by side and it works great.
I cannot for the life of me get this thing to work. Keeps saying “Tritation takes too long”