OP
OP
I guess anything is possible. Not sure how I'd check that.
Turtle's Fairy Tale
- Cube Build
- Thread starter SashimiTurtle
- Start date
- Tagged users None
I guess anything is possible. Not sure how I'd check that.
Tmm87
Well-Known Member
Not sure either short of flipping it and checking with a level. The stand top looks even at least from the pictures. I've never seen a foam mat that's done that regardless of how much it's been compressed.
Tank doesn't rock even the slightest bit, does it?
Tank doesn't rock even the slightest bit, does it?
OP
OP
Tank doesnt rock, just pulled shims and reset. Stand is stable. I really need this tank up and running. Are all rimless tanks this hard to set up?
Tmm87
Well-Known Member
Mine is a marineland rimless 60. I had no issues. Stand is solid, only issue is the carpet so some shimming was needed. This seems really odd. I've heard nothing but good things about SCA tanks.
What’s going on twinny?! I noticed the foam that came with mine was damaged due to shipping ( didn’t like that factory foam anyhow) so I bought 2 pieces of foam board from WM and placed them together. Did you run a straight edge on the bottom of the tank? I know my tank isn’t sqare it’s off by 1/8” top side l-r...
OP
OP
I think the foam is just mashed on that one side more than the other.
I'm about to set the scape back up and fill it. The stand is level, shimmed, does not rock and my floor is solid. I straight edged the top of the stand and could not find any noticible high spot. The foam will compress.
I'm losing corals due to crap filtration and poor lighting. Time to get this thing up and running. Gotta get flipped for nightshift anyway. Time to pull and all nighter. I'll see y'all in the morning, with a running tank.
Ticket and I’ll be there to help!
OP
OP
Alright, so Steve from SCA says to use 1/4" yoga mat since the foam mat was mashed. Now I gotta get someone back over here tomorrow to help pick this tank up... that's IF I can find a yoga mat. Ugh... off to Walmart.
OP
OP
Well, they have exactly one that will work. Its blue.
NY_Caveman
likes words, fish and arbitrary statistics
Well, they have exactly one that will work. Its blue.
I used a 1/4” black yoga mat cut to fit under my stand this weekend. Cut easy and works very well.
OP
OP
This one is 24"x80"x1/4"
OP
OP
One thing this old stand is good for... a template.
OP
OP
Do NOT ask me how I managed that...
Brew12
Electrical Gru
When do you see the doctor about your hernia? :DDo NOT ask me how I managed that...
Spanky05
Active Member
Good luck w the setup!
I'm in the process of setting up a 93 gal cube as well.
Did you end up going with a 230 or 250 gyre pump?
My instinct is to go for a 250 and run it super low as I've heard noise can be an issue with these.
I'm in the process of setting up a 93 gal cube as well.
Did you end up going with a 230 or 250 gyre pump?
My instinct is to go for a 250 and run it super low as I've heard noise can be an issue with these.
OP
OP
Fixing to leave for nightshift... but I managed to get this thing full and circulating water. Kessils, 1K gyre, SW4 and one of the 200W heaters are hooked up. Hopefully the sand and mud cloud will clear tomorrow, then check salinity, get ATO hooked up and fish and corals(the few I have left) will get moved over.
OP
OP
Right now, its about yeigh high over the water...
Lol, when I had the Seneye out before I set the Fixture at 6" over the water and got 400-420 PAR at the top of the rocks. I'll adjust and level it later.
Planned corals are acans, trachy, favia... those types of LPS. I've never cared for the long, stringy, tentacle looking LPS. Tops of rocks will have SPS, Stylo, monti, acros... Zoas will be scattered here and there.
Similar threads
TOP 10 Trending Threads
-
- Question
-
- Sticky
