Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Thank you for visiting the R2R Marketplace! Please consider becoming a Supporting Member today! In addition to all the perks of becoming a supporting member, this notice will also be automatically removed! Click here for more details and Happy Reefing!
Yes, in LI, NY.
Looking for 2 - 1" & 1 - 1.5" bulkhead sizes.
Something 2.5 - 3 inches high so I can grab it with my big mits.
Okie just need to find out nut sizes and can do some design. Running errands so will see what I can come up with this evening.Yes sir it is.
Shirak,
got the measurements this morning: Actual taken with calipers, nothing added for clearances.
1 inch nut-- 501mm wide & 60mm thick.
1.5 inch nut-- 693mm wide & 92mm thick.
2 inch nut-- 844mm wide & 74mm thick.
Would need 2 pieces of the 1 inch & 1 piece each of the others.
Question, is it possible to offset the handle or the open end upwards roughly 30 degrees?
These for getting into an external overflow that has a rim around the top lip?Was thinking more along the lines of the 1st diagram where the head is angled up.
I am going to trust you on exactly what angle to use. 30 degrees could be too much & I don't have a protractor to double check.
Thanks, Vinny